- Hisco
- SCS Static Control
- SCS ESD Monitors
Verify reliability with an ESD monitor from SCS
Explore three options for a range of applicationsWhen it comes to ESD protection, reliability should never be in question. And, with features suited for a variety of unique environments and applications, an SCS workstation monitor can offer your best defense against overvoltage and potential damage caused by electrostatic discharge. SCS offers three levels of protection to address varying requirements — so whether your focus is simple installation or communication across an entire network, you’ll find the ideal fit for any application.
Need help with selecting the right ESD monitor? Contact us!
724 Workstation Monitor
-
Adjustable Operator Test Voltage and Upper Limit
Test voltage can be set to 9 or 16 volts; test limit can be set to 10 or 35 megohms.
-
Continuously Monitors Two Operator Dual-Wire Wrist Straps and One Work Surface Mat
Visible and audible alarms indicate improper grounding of the operator and work surface.
-
Adjustable Audible Alarm
Buzzer volume may be disabled or set to loud or soft.
-
Simple Installation and Setup
Mounting hardware and wire management clips are included.
-
Top Seller
Iron Man® Plus Monitor
-
Digital Signal Processing Technology
Applies a low test voltage to the operator (0.40V) for the handling of sensitive components.
-
Electrical Overstress (EOS) Detection
Alarms if overvoltage from a tool is applied to a circuit board under assembly.
-
IPC-A-610 Appendix 3.1.1 EOS/ESD Prevention
Current research indicates that voltages and spikes less than 0.5V are acceptable.
-
Operator Body Voltage Detection
Alarms if the operator generates or comes in contact with a voltage that would be dangerous to an ESD-susceptible item.
WS Aware Monitor
-
Digital Signal Processing Technology
Applies an ultra-low test voltage to the operator (0.50V) for the handling of sensitive components.
-
Dual Workstation Continuous Monitor
Continuously monitors the path-to-ground integrity of two operators, two conductive or dissipative work surfaces, and two metal tools; meets ANSI/ESD S20.20 in accordance with ESD TR1.0-01-01.
-
EMI Monitoring on Metal Grounds
Alarms of the grounded metal tools have high-frequency noise that could cause electrical overstress (EOS) damage.
-
NEW Ethernet Connectivity
Provides network communication with static management program.
-
NEW Optical Relay Terminal
Pairs with lights and buzzers for increased visibility.
| Industry Applications | 724 | Iron Man Plus | WS Aware |
|---|---|---|---|
| Contract Manufacturers |  |
|
|
| OEM | |
|
|
| General Electronics Manufacturers | |
||
| Medical Electronics | |
| |
| Disk Drive Assembly | | ||
| Semiconductor Fabrication | |